GFO and Phosban can remain in place since the media only removes phosphates. Empty 1 capsule for every 10 gallons of tank water (20mg per gallon) into high flow…
How long does Gfo take to reduce phosphates?
Standard BRS Granular GFO: A cost-effective solution for everyday phosphate control. (16 tbsp = 1 cup). After 4-8 weeks the aquarium will have adjusted to lower nutrient levels and the amount of GFO can be increased up to 2 tablespoons per 4 gallons of water.
How do you open a Phosban reactor 150?
Open reactor lid by turning counter clockwise. Check parts list to confirm that all parts are present. The reactor is supplied with all the parts needed to operate it except for the hose and pump.
How much flow does a Gfo need?
The general rule of thumb for GFO is to start with 1 tbs per 8 gallons of water for the first 4-8 weeks if you have never run it in the tank before. 16 tbs = 1 cup. After the initial 4-8 weeks, you can bump up to double the dose. 2 tbs per 8 gallons.
How long does Phosban last?
PhosGuard™ needs to be replaced every 4 days as long as there is a phosphate problem because, given an infinite amount of available phosphate, PhosGuard™ absorbs phosphate so quickly that it reaches its full capacity in 4 days.
How often should you change phosphate media?
every 4 weeks
Change GFO when phosphate levels begin to rise. This is generally every 4 weeks for standard GFO and closer to 8 weeks for High Capacity GFO.
How does a media reactor work?
A media reactor is an aquarium filtration device that contains filter media. It helps to increase the effectiveness of the filter media inside by forcing all water that enters the reactor to come in contact with the media.
Can you use too much Gfo?
Yes absolutely! You should monitor your po4 levels and use enough to keep your po4 in check but not much more. If too much is used it can be too aggressive at nutrient removal and cause necrosis – ususally on SPS. It’s also costly, so using more than is needed is not cost effective nor is it going to benefit.
What are the operating instructions for the phosban reactor 150 ™?
Operating Instructions for the PhosBan Reactor 150 ™ Technical Data Capacity Use with up to a maximum of 200 grams (385 ml) of PhosBan, or a media height of 5 inches (13 cm). Aquarium size One reactor for up to 150 gallons (568 Liters). Multiple reactors may be used for larger aquariums. Recommended flow rate ca. 20 – 30 gal/hr (75 – 115 l/hr).
How much phosban can I put in my Aquarium?
Technical Data Capacity Use with up to a maximum of 200 grams (385 ml) of PhosBan, or a media height of 5 inches (13 cm). Aquarium size One reactor for up to 150 gallons (568 Liters). Multiple reactors may be used for larger aquariums. Recommended flow rate ca. 20 – 30 gal/hr (75 – 115 l/hr).
Can phosban be mixed with activated carbon?
PhosBan may be mixed with phosphate-free activated carbon (HydroCarbon2 from Two Little Fishies). This can provide the necessary media volume when less than 100 grams (190 ml) of PhosBan is used. Do not place ball valve on the exit pipe. Restricting the flow on the exit pipe pressurizes the reactor and can cause leaks.
