You must cycle the vehicle’s ignition between the on and acc/off position 5 times within 7 seconds or less and then tap the lock button, button I, or put the battery in the remote (2WSSR / P2WSSR). The process depends on which remote(s) you have. All your remotes must be reprogrammed at the same time.
How do I reset my Compustar remote starter?
Press and hold the foot brake down. While keeping your foot on the brake, press the remote start button on your remote control for 2.5-3 seconds. Your parking lights will flash once. Turn off your vehicle’s engine and remove the key from the ignition.
What is Tach learning procedure?
Tach learning procedure: Learn tach by: (1.) Starting the vehicle with the key, (2.) Press and hold the foot brake, then (3.) Activate the remote start sequence – one chirp and parking light flash indicates that the vehicle tach signal has been successfully learned.
What is tach sensing?
A tachometer is a sensor device used to measure the rotation speed of an object such as the engine shaft in a car, and is usually restricted to mechanical or electrical instruments. This device indicates the revolutions per minute (RPM) performed by the object. Advanced tachometers have novel uses.
How does a Compustar remote start work?
On most push-to-start vehicles, Compustar remote starters use a secure, proprietary technology called KLON* that mimics your vehicle’s smart-key signal to start your engine. Thus, when you remote start your push-to-start vehicle, your engine will start as if your smart-key was physically inside of your vehicle!
How do I reset my Compustar remote start?
What wires do I connect to the cm-900 slot?
Page 10 Pin 8 Black – Ground negative (-) input. This wire must be connected to the vehicle’s ground. Connector 2 (CN2) Blade Connector and Cartridge The CM-900 slot gives you the ability to use the Blade-AL and Blade-TB modules from Firstech and ADS.
How do I program options on the cm-900 control modules?
Option Programming How to Program Options There are two ways to set options on the CM-900 control modules. You can use the FT-OP500 or most Firstech remotes. The remotes include 4 or 5 button 1 and 2 Way remotes. Option Programming Using the FT-OP500 The OP500 can be used to change anything in the Option Tables.
How do I code multiple remotes on the cm-900?
STEP 2, you can code additional remotes by tapping the Lock button on the remote (s). The parking lights will flash once confirming each additional remote. The CM-900 can store up to three remotes. Exiting Programming: Programming is a timed sequence. The parking lights will flash twice signaling the end of programming mode. “Smart Resting Mode”.
How long does the cm-900 take to start?
The CM-900 will release the starter once the idle tach voltage is met. Page 20 FO1 – 3 hour cycle: (4 minute runtime, 8 minute runtime for diesel) Once Timer Mode is enabled (see feature 2-13) the CM-900 will wait 3 hours, remote start and run for 4 minutes unless the cold start feature is enabled.
